Bảng mạch phát triển Stm32F103C8T6 Arm Stm32 chuyên dụng dùng cho Arduino

CH32F103C8T6 chip is compatible with the standard STM32F103C8T6 series chip, all pins are compatible, all registers are compatible, but the USB function is enhanced. There are 2 usbs, a host, and a device, which have stronger functions and lower cost. However, the flash download algorithm is different from the internal BootLoader and the compatibility of the st company. ST's download software cannot be used, but the official software download is also very convenient. You can use the serial port and USB. The USB method is faster and is not required Develop additional BootLoader.

For the specific parameters of the chip, please refer to the official data sheet and application manual in the data package. The following mainly introduces the next three download modes.



(1) STLINK（Download in Keil project）

Note: For development code and drivers, please refer to the official EVT package

Here is an example of the GPIO_PC13LED project. Note that debugging only supports SWD.



1.Install the device library, find the device library file in the EVT folder (you must install to find the device) Keil.WCH32F1xx_DFP.1.0.0.pack, open and install.



EVT download link：http://www.wch.cn/downloads/CH32F103EVT_ZIP.html